NXP Smart Key Adapter P/N: MCKB007 For Toyota Land Cruiser

NXP Smart Key Adapter P/N: MCKB007 For Toyota Land Cruiser

The MCKB007 Solder-Free Adapter is a dedicated interface board for Toyota Land Cruiser smart key remotes. Instead of soldering wires onto the remote's fragile test points, you seat the key PCB into the 3GZK-07FT-V3.1 fixture, close the two clamps, and the spring-loaded pogo pins make contact automatically.

A major advantage of this adapter is its broad tool compatibility — it can be used with KYDZ, KD, VVDI, N51 and other common key programmers. All required lines are broken out and clearly silk-screened along the bottom edge of the board: MSCL, GND, WAKE, MSDA and VCC, alongside a multi-pin connector socket for ribbon harness use. An orange WAKE probe lead with a gold-plated tip is supplied for remotes that need a wake-up signal before they will respond.

Key Features

• Solder-free operation – gold-plated pogo pins contact the PCB test points directly; no heat or flux required.
• Wide programmer compatibility – works with KYDZ, KD, VVDI, N51 and other mainstream key programming tools.
• Twin clamp fixture – two adjustable screw clamps hold the key board flat and correctly aligned every time.
• Clearly labelled pinout – MSCL, GND, WAKE, MSDA and VCC marked along the board edge for fast, unambiguous wiring.
• Included WAKE probe – orange lead with gold probe tip for wake-up dependent remotes.
• Printed key outline – the PCB footprint is silk-screened on the board so positioning is obvious.
• Connector socket included – on-board multi-pin socket for use with a ribbon harness.
• Consistent contact pressure – fewer failed reads and fewer retries across repeat jobs.
• Workshop ready – supplied in a protective clear storage case, ideal for mobile work.

What It Does

The MCKB007 acts as the physical bridge between a Toyota Land Cruiser smart key PCB and your key programming device. Once the remote board is clamped in place and the harness is connected, your tool can communicate with the onboard chip to carry out key and remote programming operations. It replaces the traditional method of soldering flying leads onto the remote, which is slow, risky, and often leaves permanent marks on a customer's key.

Package Includes

• 1 x MCKB007 Solder-Free Smart Key Adapter (3GZK-07FT-V3.1 board)
• 1 x WAKE probe wire

Note: This adapter is a hardware interface only. A compatible key programming device and the relevant software licence are required to perform key programming operations.